Skip to content

What is Active High Beam technology?

Introduction

Many people will not often be the on-coming vehicle or the vehicle lights ldquo; Akira blind rdquo ;. This practice is not only a moral shortcoming, it will cause traffic problems. In order to eliminate the factors driving these unstable, Volvo recently announced a new research initiative headlight technology mdash; mdash; Active High Beam technology.

# 8203; While in accordance with Article 48 of “Road Traffic Safety Law”: traffic lights turn on the road or other illumination preferably should not open High beam. Turn on the high beam of the vehicle should switch to low beam lights before the car in front will be 150m, but still people disregard the feelings of others insisted on the use of high beam driving. Wrong use the high beam will cause the front car, opposite the driver instantly blinding, so that driver’s speed and distance perception of decline, down to the width of judgment and so on, following this actual picture may allow you to clearly see that the incorrect use of lights and murder almost no different.

Active High Beam technology and the use of the vehicle located in front of the two optical camera scanning the road ahead in the traveling and walking before the wind pedestrians, and as positioned in the shutter control based headlamps group, eventually occlusion region of about 1.5 inches to maintain the vehicle width of the front, but only the optical scanning camera 15 within a range of the road before the vehicle. # 8203; # 8203;

When the optical scanning camera to the road with a preceding vehicle or object appears to car, headlights located within the baffle set based on the width of the preceding vehicle or a vehicle in the automatic block large lighting lamps within the corresponding region, and the camera continuously scans the vehicle and the leading vehicle, the distance to the car, and continuously control the position of the shutter flap area, play to reduce interference lights of the preceding vehicle and the driver’s line of sight through the light shielding effect until the front of the car or the car will cancel always exceed the truck driver line of sight blocked.

In the actual road conditions, not only to the front of the vehicle and running, there will be a pedestrian walk, itPeople at night has been to drive the glare of the lights and short-term blindness experience. If at this time appeared in front of potholes or obstructions, accidents can easily occur. When Active High Beam technology to detect when a pedestrian street, the lights will automatically adjust the height, so that the light is always lower than the pedestrian head, avoid direct light pedestrian eye. This feature will also vary from the vehicle with a pedestrian, to constantly adjust the height of the light, to achieve both protection of pedestrians without losing the effect of the illumination range.

# 8203;

Related video:

This video image below shows the effect of the practical application of the Volvo High Beam technology Active , you can clearly see this technology on the front of the car, the car has always been protective effect, for pedestrians, it is recommended viewing.

more exciting video, all in video channel

Leave a Reply

Your email address will not be published. Required fields are marked *

Exit mobile version